4600 Serien, Candy

Nyhedsbrev

Nyhedsbrev

4600 Serien, Candy

Concentrated – Reduce Candy Pigment 3:1 4011 Flash Reducer Candy – Pigments are transparent colors used for mid-coats over 4100 or 4300 Series Colors or as airbrush color. Colors are pigment-based, transparent colors, not dye-based (except for 4604 Brite Red), minimizing bleeding. Candied effect observed after top-coat, gloss clear applied. Add ...

Concentrated – Reduce Candy Pigment 3:1 4011 Flash Reducer Candy – Pigments are transparent colors used for mid-coats over 4100 or 4300 Series Colors or as airbrush color. Colors are pigment-based, transparent colors, not dye-based (except for 4604 Brite Red), minimizing bleeding. Candied effect observed after top-coat, gloss clear applied. Add 4501 Hot Rod sparkle White to any Candy – Pigment for pearl-flake candy color. Spray Gun: 1.0mm – 1.2mm tip-size, touch-up gun 0.8mm operated @ 40 PSI Apply in multiple light coats, 5 – 6 coats required for full finish After thorough curing, top-coat with a catalyzed, urethane clear

Mere

4600 Serien, Candy 17 varer

Underkategorier

  • Candy2O
    Candy2o farverne er Dye-baserede og ikke et pigment som de almindelige Candy farver hvilket giver dem en meget intens farve efter få lag og gør dem meget nemmere at arbejde med. 4600 Series candy₂O - TRUE CANDY PERFORMANCE Brilliant transparent colors for custom refinishing and airbrushing. candy₂O combine advanced water-soluble, urethane resin technology with crystal-clear dyes to create truly exceptional candy colors. candy₂O are concentrate. Add 10% per volume (9:1 mix ratio) 4030 Intercoat for spray performance. Optional lowering of viscosity is achieved by reducing with either 4012 High Performance or 4020 Automotive Reducer. candy₂O are intense. 4 – 6 medium wet coats are recommended for full color saturation. Allow each coat to air dry tack free prior; approximately 10 minutes flash time in between coats when painting in non-humid, temperate conditions. candy₂O are made for the graphic arts with excellent adhesion so they will not lift or peel when taped on. Apply 4030 Intercoat direct over air-driedcandy₂O to prevent bleeding when applying other colors and marking when taping. candy₂O work with a wide variety of spray-gun and airbrushes. The following specs are recommended as a starting point. As always, achieving a finely atomized spray pattern is the goal. Reduce and adjust settings & psi to achieve a spray pattern that is smooth and free of large, color droplets or a “grainy” over-spray look. spray-gun: 1.2 – 1.3mm tip, 25 – 35 psi mini-gun: 0.8 – 1.0mm, 25 – 35 psi airbrush: 0.5mm - mixing with 4030 generally enough, smaller tip-sizes reduce with 4012 High performance or 4020 Automotive Reducer as needed to achieve optimum atomization
Viser 1 - 17 af 17
Viser 1 - 17 af 17